Many of the Launch Control 3’s features can be controlled by MIDI CC messages sent to the Launch Control 3's DAW in port on channel 7 and queried by sending the same message to channel 8. Reply messages confirming changes or answering queries will always be sent on channel 7.
To enable or disable these controls in standalone mode, use the below messages.
Enable feature controls:
Hex: 9Fh 0Bh 7Fh
Dec: 159 11 127
Disable feature controls:
Hex: 9Fh 0Bh 00h
Dec: 159 11 0
-
In DAW mode, all feature controls are listening, but will not send the confirmation reply except for a few essential ones.
-
In DAW mode, the above messages can be used to enable all of them or revert to the DAW set.
-
The CC messages must be sent to the Launch Control 3's DAW in MIDI port.
-
Features marked with (*) are non-volatile, persisting across power cycles.
-
Features marked with (#) are always fully enabled in DAW mode.
|
CC Number |
Feature |
Control type |
|
|---|---|---|---|
|
Hex |
Decimal |
||
|
1Eh (#) |
30 (#) |
Surface mode select |
DAW Mixer: 01h (1) DAW Control: 02h (2) Custom Modes 1-4: 06h-09h (6-9) Custom Modes 5-16: 12h-1Dh (18-29) |
|
3Fh (#) |
63 (#) |
Shift |
On/Off |
|
45h (#) |
69 (#) |
DAW Encoder, Row 1 Relative output |
On/Off |
|
48h (#) |
72 (#) |
DAW Encoder, Row 2 Relative output |
On/Off |
|
47h (#) |
71 (#) |
DAW Touch events |
On/Off |
|
6Fh (*) |
111 (*) |
LED brightness level |
00h - 7Fh (0 – 127) where 0 is min, 7Fh/127 is max. |
|
70h (*) |
112 (*) |
Screen brightness level |
00h - 7Fh (0 – 127) where 0 is min, 7Fh/127 is max. |
|
71h (*) |
113 (*) |
Temporary display timeout |
00h - 63h (0 - 99) 1/10 sec units, minimum of 1 sec at 0. |
|
78h (*) |
120 (*) |
Out2 MIDI Thru Enable/Disable |
On/Off |
|
64h (*) |
100 (*) |
Global MIDI channel |
00h - 0eh (0 - 15) where 00h (0) is channel 1 and 0Eh (15) is channel 16. |
|
Hex - 79h (*) |
Dec - 121 (*) |
Encoder Curve |
Slow 00h (0) Medium 01h (1) Fast 02h (2) |